Operation of diagnostix, Palm aneroids, Connecting gauge to cuff – American Diagnostic Corporation (ADC) Diagnostix 75XX User Manual
Page 4: Using the trigger valve, Clock aneroids

Most models are preassembled and ready for use. In units requiring assembly, the bulb and
valve should connect to the tube closest to the Index Line. The gauge connects to the re-
maining tube.
Operation of Diagnostix
TM
Palm Aneroids
This booklet contains operating and mainte-
nance information for the DIAGNOSTIX
TM
703,
788 Series, System 3, Pediatric, General Prac-
tice, System 4 and System 5 Multicuff instru-
ments. Please read and retain.
Your DIAGNOSTIX
™
palm style aneroid
manometer with integral bulb and trigger air
release valve (#804N), ADCUFF™ calibrated
cuff with Size Guide
™
marking system, blad-
der, luer slip connector (attached to bladder
tubing), zippered carrying case, and instruction booklet. ADC
®
’s
Multicuff Systems (System 3, 4, 5, GPK, and PMK) contain the
#804 manometer and a variety of cuffs with single tube bladders,
each equipped with a luer slip connector, and a compartmental-
ized case.
Connecting Gauge to Cuff
To connect the cuff to the gauge insert the luer slip connector at the end of the bladder
tube into the receptacle on the top of the gauge with a firm twist until secure. To re-
move, reverse procedure.
NOTE:
To avoid damage to the instrument, do not force connection
into port. 1/16th inch of connector should remain visible.
Using the Trigger Valve
Deflation: Gently squeeze the bottom of the trigger to deflate the cuff. Altering
the pressure affects the deflation rate.
Rapid Exhaust: To exhaust remaining air after measurement is completed, squeeze trigger until
it clicks and locks in place.
Caution: Never force trigger.
Operation of Diagnostix
TM
Clock Aneroids
This booklet contains operating and maintenance information for the DIAGNOSTIX
™
750W series,
Wall Mount, 752M series, Mobile and 750D series, Desktop Aneroid Sphygmomanometers.
Please read and retain.
Your DIAGNOSTIX
™
750/752 consists of a large “clockface” aneroid with easy-to-read 6” dial, an
integral swivel bracket/cuff storage compartment (wall series only), complete inflation system
(which includes the ADCUFF
™
nylon cuff with Size Guide
™
marking system, latex-free inflation
Connector
Cuff
Bladder Tubing
Trigger Valve
Gauge
Artery Mark
Connector Port