beautypg.com

Automatic transmission – Acura 2001 Integra Sedan - Owner's Manual User Manual

Page 141

background image

Automatic Transmission

Drive (D

3

) —This position is similar

to D

4,

except only the first three

gears are selected. Use D

3

when

towing a trailer in hilly terrain, or to
provide engine braking when going

down a steep hill. D

3

can also keep

the transmission from cycling
between third and fourth gears in

stop-and-go driving.

For faster acceleration when in D

3

or

D

4

, you can get the transmission to

automatically downshift by pushing

the accelerator pedal to the floor.

The transmission will shift down one

or two gears, depending on your
speed.

Second (2) — To shift to Second,

press the release button on the side
of the shift lever. This position locks
the transmission in second gear. It
does not downshift to first gear

when you come to a stop. Second
gives you more power when climbing,

and increased engine braking when

going down steep hills. Use second
gear when starting out on a slippery
surface or in deep snow. It will help
reduce wheelspin.

First (1) — To shift from Second to

First, press the release button on the
side of the shift lever. With the lever
in this position, the transmission
locks in First gear. By upshifting and
downshifting through 1, 2, D

3

and D

4

,

you can operate this transmission
much like a manual transmission
without a clutch pedal.

Engine Speed Limiter

If you exceed the maximum speed

for the gear you are in, the engine

speed will enter into the tachometer's
red zone. If this occurs, you may feel

the engine cut in and out. This is
caused by a limiter in the engine's
computer controls. The engine will
run normally when you reduce the
RPM below the red zone.

Driving

Main Menu

Table of Contents