Acura 2005 NSX - Owner's Manual - Manual (Page 93)

Press the REPEAT
(Preset 3) button to continuously
play a song or passage. The indicator
in the button lights and stays on. The
track will repeat until you press the
RPT button again.
Press the REPLAY
(Preset 1) button to play the current
song or passage from the beginning.
The system goes into rewind, and
the indicator in the button flashes
during rewind. When it reaches the
current song or passage, it goes back
to PLAY.
Press the SCAN (Preset 2)
button to search the tape for a
desired passage. When you press the
SCAN button, the system goes into
fast forward. It goes back to PLAY
when it reaches the beginning of the
next song or passage. It plays that
song or passage for about 8 seconds
and then goes into fast forward again
to find the beginning of the next
song or passage. The system repeats
this until you press the SCAN button
again.
The SKIP, REPEAT,
REPLAY and SCAN functions use
silent periods on the tape to find the
end of a song or passage. These
features may not work if there is
almost no gap between selections, a
high noise level, or a silent period in
the middle of a selection.
The tape player picks up dirt and
oxides from the tape. This
contamination build up over time and
causes the sound quality to degrade.
To prevent this, you should clean the
player after every 30 hours of use.
If you do not clean the tape player
regularly, it may eventually become
impossible to remove the
contamination with a normal
cleaning kit. Your dealer has a
cleaning kit available.
CONTINUED
Playing a Tape
REPEAT
REPLAY
Caring f or the Tape and Player SCAN
Fe
a
tu
re
s
91
NOTE:
Main Menu Table of Contents