Acura 2005 NSX - Owner's Manual - Manual (Page 162)

Disconnect the blade assembly
from the wiper arm by pushing in
the lock tab. Hold the lock tab in
while you push the blade assembly
toward the base of the arm.
Check the condition of the wiper
blades at least every six months.
Replace them if you find signs of
cracking in the rubber, areas that are
getting hard, or if they leave streaks
and unwiped areas when used.
To replace a wiper blade:
Turn the ignition switch to ON (II),
switch the wipers to INT or
(low position), then turn the
ignition switch to OFF when the
wiper arm is approximately
midway in its travel.
2.
1.
Wiper Blades
160
LOCK TAB
Do not open the hood when the wiper
arms are raised, or you will damage the
hood and the wiper arms.
Main Menu Table of Contents