Acura 2005 NSX - Owner's Manual - Manual (Page 82)

When button is pressed, the
indicator in the button comes on and
the air flows from the defroster
vents at the base of the windshield.
This overrides any MODE selection
you may have made.
The flow-through ventilation system
draws in outside air, circulates it
through the interior, then exhausts it
through vents behind the seat-backs.
The heater uses engine coolant to
warm the air. If the engine is cold, it
will be several minutes before you
feel warm air coming from the
system.
Select .
Select and Fresh Air mode.
Set the fan to the desired speed.
Adjust the warmth of the air with
the temperature control dial.
Air conditioning places an extra load
on the engine. Watch the engine
coolant temperature gauge (see page
). If it moves near the red zone,
turn off the A/C until the gauge
reads normally.
Turn on the A/C by pressing the
button. You will see A/C ON in
the display.
If the outside air is humid, select
Recirculation mode. If the outside
air is dry, select Fresh Air mode.
Set the fan to the desired speed.
you can
cool it down more rapidly by partially
opening the windows, turning on the
A/C, and setting the fan to
maximum speed in Fresh Air mode.
Set the temperature to the lower
limit.
Make sure the A/C is off.
Select
and Fresh Air mode.
Set the fan to the desired speed.
Make sure the temperature is set
to maximum cool.
1.
2.
3.
1.
2.
3.
4.
5.
47
1.
2.
3.
4.
If the interior is very warm,
Vents, Heating, and A/C
Windshield Def roster Button
Ventilation
Using the Heater
Using the A/C
80
Main Menu Table of Contents