Acura 2006 RSX - Owner's Manual - Manual (Page 95)

You can use these five methods to
find radio stations on a selected
band:
the
preset buttons, and .
Use the TUNE knob to
tune the radio to a desired frequency.
Turn the knob right to tune to a
higher frequency, or left to tune to a
lower frequency.
The SCAN function
samples all the stations with strong
signals on the selected band. To
activate it, press the SCAN button,
then release it. You will see SCAN in
the display. The system will scan for
a station with a strong signal. When
it finds one, it will stop and play that
station for about 5 seconds. If you do
nothing, the system will then scan
for the next strong station and play it
for 5 seconds. When it plays a station
that you want to listen to, press the
SCAN button again.
The band and frequency that the
radio was last tuned to is displayed.
To change bands, press the AM/FM
button. On the FM band, ST will be
displayed if the station is broadcast-
ing in stereo. Stereo reproduction on
AM is not available.
The SEEK function
searches up and down from the
current frequency to find a station
with a strong signal. To activate it,
press either (
or ), then
release it.
The ignition switch must be in the
ACCESSORY (I) or ON (II) position.
Turn the system on by pressing the
PWR/VOL knob, or the AM/FM
button. Adjust the volume by turning
the knob.
To Play the Radio
To Select a Station
TUNE, SEEK, SCAN,
AUTO SELECT
TUNE SCAN
SEEK
Playing the Radio
94
Main Menu Table of Contents