Acura 2006 RSX - Owner's Manual - Manual (Page 62)

Turning the switch to the ‘‘ ’’
position turns on the headlights. If
you leave the lights on with the key
removed from the ignition switch,
you will hear a reminder beeper
when you open the driver’s door.
To turn on the high
beams, push the left lever forward
until it clicks. The blue high beam
indicator will come on (see page
).
Pull it back to return to low beams.
To flash the high beams, pull the
lever back lightly, then release it.
The high beams will stay on as long
as you hold the lever back.
Push down on the
left lever to signal a left turn and up
to signal a right turn. To signal a lane
change, push lightly on the lever,
and hold it. The lever will return to
center when you release it or
complete a turn.
The headlights revert to normal
operation when you turn them on
with the switch.
With the headlight switch off, the
high beam headlights come on with
reduced brightness when you turn
the ignition switch to the ON (II)
position and release the parking
brake. They remain on until you turn
the ignition switch off, even if you
set the parking brake.
Turn signal
Off
Parking and interior lights
Headlights
High beams
Flash high beams
Turning the switch to
the ‘‘ ’’ position turns on the
parking lights, taillights, instrument
panel lights, side-marker lights, and
rear license plate lights.
1.
2.
3.
4.
5.
6.
54
Canadian model only
Turn Signal and Headlights Daytime Running Lights
High Beams
Turn Signal
Headlights
Turn Signal and Headlights
Inst
ru
m
e
nt
s
a
nd
Cont
ro
ls
61
Main Menu Table of Contents