Acura 2006 RSX - Owner's Manual - Manual (Page 112)

Dolby noise reduction turns on
when you insert a tape. The
indicator will come on in the
display. If the tape was not recorded
in Dolby, turn it off by pressing the
NR (
) button. Dolby remains
off until you press the NR ( )
button again.
To remove the tape, press the
EJECT button. If you want to turn
the player off, press the PWR/VOL
knob or turn off the ignition. The
tape will remain in the drive. When
you turn the system back on, the
tape will begin playing where it left
off.
The ignition switch must be in the
ACCESSORY (I) or the ON (II)
position. Make sure the open side of
the tape is facing right, then insert
the tape most of the way into the slot.
The system will pull the tape in the
rest of the way and begin to play it.
The tape direction indicator in the
display comes on to show you which
side of the tape is playing. The
indicates the side you inserted
upward is now playing. If you want to
play the other side, press the PROG
button. When the player reaches the
end of the tape, it will automatically
reverse direction and play the other
side.
To switch to the radio or CD
changer while listening to a tape,
press the AM, FM, or CD button. To
change back to the tape player, press
the TAPE button.
To rewind the tape,
push the REW button. You will see
REW in the display. To fast forward
the tape, push the FF button. You
will see FF displayed. Press the FF,
REW, PLAY, or PROG button to
take the system out of rewind or fast
forward.
CONTINUED
Dolby noise reduction is manufactured under
license from Dolby Laboratories Licensing
Corporation. ‘‘DOLBY’’ and the double-D symbol
are trademarks of Dolby Laboratories
Licensing Corporation.
Playing a Tape
To Play a Tape
To Stop Playing a Tape
FF/REW
Tape Search Functions
Fe
a
tu
re
s
111
Main Menu Table of Contents