Acura 2006 RSX - Owner's Manual - Manual (Page 55)

Only on models equipped with Cruise
Control System
This indicator comes on when you
set the cruise control. See page
for information on operating the
cruise control.
This indicator comes on for a few
seconds when you turn the ignition
switch to the ON (II) position. It will
go off if you have inserted a
properly-coded ignition key. If it is
not a properly-coded key, the
indicator will blink and the engine
will not start (see page
).
This indicator also blinks several
times when you turn the ignition
switch from the ON (II) position to
the ACCESSORY (I) or the LOCK
(0) position.
The left or right turn signal indicator
blinks when you signal a lane change
or turn. If an indicator does not blink
or blinks rapidly, it usually means
one of the turn signal bulbs is
burned out (see page
). Replace
the bulb as soon as possible, since
other drivers cannot see that you are
signaling.
When you press the hazard warning
button, both turn signal indicators
and all turn signals on the outside of
the vehicle flash.
This indicator comes on if either
door or the hatch is not closed
tightly.
This indicator comes on with the
high beam headlights. For more
information, see page
.
On Canadian models, this indicator
comes on with reduced brightness
when the daytime running lights
(DRL) are on (see page
).
65
186
61
61
127
Instrument Panel Indicators
Cruise Control Indicator Turn Signal and
Hazard Warning
Indicators Immobilizer System
Indicator
Door and Hatch Open
Indicator
High Beam Indicator
54
Main Menu Table of Contents