Entering a destination – Acura 2007 MDX - Navigation Manual User Manual

Page 46

Navigation System

By Map Input

After you select

Map Input

from the

Enter destination by

screen, the

display changes to:

NOTE:
• Prior to departure, you can set areas

to avoid. The system then includes
them in its calculations for the
destination you have entered. See
Edit Avoid Area on page 96.

• For information on the available

voice commands, see Voice
Command Index on page 140.

Showing the Map of Current
Position

The

Current Position

selection

assumes that you are looking for a
destination in the immediate area. The
display changes to:

The red arrow indicates your vehicle
position. Find your desired destination
by moving the

Interface Dial

left,

right, up, or down. The map and cross
hairs will move in the same direction.

If desired, rotate the

Interface Dial

knob

to change the map scale. When

you have the cross hairs on the desired
icon, map feature, or road. Then push in
on the

Interface Dial

. The address of

the road segment will appear at the top
of the screen.

The yellow box indicates the area you
will see when you click on the current
map with the Interface Dial.

NOTE:
The address of the road segment will be
displayed on the 1/20, 1/8, 1/4, or 1/2
mile (80, 200, 400, or 800 m) scale map.

If this is the desired destination, push in
on the

Interface Dial

again. If not, use

the

Interface Dial

to reposition the

cross hairs, then push in on the

Interface Dial

again to display the new

address.

Once you select an address, the system
then displays the

Calculate route to

screen (see Driving to Your Destination
on page 50).

Entering a Destination