System set-up – Acura 2007 MDX - Navigation Manual User Manual
Page 101
100
Navigation System
System Set-up
Auto Daylight
Sets automatic daylight saving time
ON
or
OFF
. If you reside in a state or area
where daylight saving time is not used,
then you may want to turn this feature
off.
NOTE:
If you set Auto Daylight to
ON
, the Auto
Daylight function is activated even in an
area that does not adopt the Auto
Daylight system.
The federal government has mandated
that, starting in 2007, daylight savings
time will change in March & November
instead of the old schedule in April &
October. The new government daylight
savings time schedule is subject to
review and possible cancellation in
2008.
At the time your navi DVD was
produced, the navi is programmed to
change its clock in April/October. The
dates that the navi switches between
standard and daylight savings time are
stored in the navi software, and is not
triggered by GPS satellite signals.
Therefore your navi clock will change
based on the old daylight savings time
schedule (April/October). To minimize
inconvenience caused by the new law,
we recommend the following:
1. The
Clock adjustment
screen in the
Setup, set Auto Daylight to
OFF
.
2. When it is time to adjust the clock for
daylight savings time, go to the
Clock
adjustment
screen in the Setup.
3. Select
Time Adjustment
and
simply adjust the navi time using the
Interface Dial
by one hour.
Auto Time Zone
Sets automatic time zone selection by
GPS
ON
or
OFF
. If you are driving
across the country and passing through
time zones, then this feature will
automatically set the time to the time
zone you are traveling through.
However, if you live and work in two
different time zones, you may want to
turn this feature off.
NOTE:
When driving near a time zone
boundary, the displayed time zone may
fluctuate between the two zone times.