A&D Weighing MPA-1200 - Manual (Page 14)

12
7-3 Exchange selectable power plug
The A-Type power supply plug is originally attached to the AC adapter. Please
change the power supply plug to the one that suits your location.
Exchange method
1. As shown, remove the power supply plug from the AC adapter.
2. As shown, put on the power supply plug that you want to use.
7-4 Before operating the pipette
Holding the pipette
- Hold the pipette so that the finger hook is between a forefinger and middle finger.
- To aspirate or dispense a liquid, operate the Operation key or the Up key
below the display. Operate the Operation key using the forefinger, as shown
in the figure below.
- Operate the eject button by using the thumb to remove the tip.
Operating mode and standby mode
- The pipette goes into standby mode to reduce the battery wasting to minimize
battery use if the pipette is idle for 10 minutes.
- When off, the pipette can be returned to the operation mode by pressing any key,
and information such as setting volume will be displayed on the display (Refer to
example of the display), enabling dispensing. At this time, the pipette automatically
positions the built-in piston to the initial default position.
- While in the operating mode, holding down the Operation key for approx. five
seconds will turn the pipette off.
Operation key Finger hook
Eject button
Example of display
or or
1. Remove the power supply plug. 2. Put on an appropriate power supply plug.
BF-Type C-Type S-Type A-Type
AC adapter