Kofax Communication Server 9.2.0 - Manual (Page 93)

Environment Guide Version 9.02.00
© Copyright Kofax, Inc. All information is subject to change without notice. 93
Menu
Pressing mode at any time (except directly after booting) brings up the menu. Pressing mode again cycles
through the menu items, pressing Set selects a menu item. Pressing mode after the last menu item returns
to standard display. The menu structure is outlined below:
Line Server ONE
5/32 Lines OK
DSP Status? 1
Select with Set Settings? 2
Select with Set Versions? 3
Select with Set Reboot? 4
Select with Set
DSP0 Status 1-1
Active
DSP1 Status 1-2
Idle
DSP2 Status 1-3
Not installed
DSP3 Status 1-4
Not installed
IP Address 2-1
10.11.2.27
Netmask 2-2
255.255.255.0
IP Gateway 2-3
10.0.0.1
Mode
Set Set
Version Info 3-1
TCBios 2.00
Version Info 3-2
TCLinux 1.05
Version Info 3-3
CS1: 1.00.28
Version Info 3-4
DSP SW 7.46.02
Press Set to
reboot
Rebooting...
Set
Set Set
Mode
Model 305 Menu structure
Below we describe each menu in greater detail.
DSP status
Displays the current status for each DSP. Status can be one of the following:
Not installed: There is no TC22 module in the corresponding slot.
Idle: The TC22 module is currently not in use. This is the status before TCOSS connects to Model 305.
Booted: The TC22 module is loaded and running but does not process any data yet.
Active: The TC22 module is active.
Shut down: The TC22 module has been shut down, for example if TCOSS was disconnected.
DSP0 is the innermost module in Model 305. Press either mode or set to cycle through DSP0-DSP3. After
DSP3 you return to the main menu.
Settings
Displays IP address, Net mask and default gateway. Pressing Mode cycles through the parameters,
pressing set allows changing a parameter.