Kofax Communication Server 9.1 - Manual (Page 112)

Environment Guide Version 3.00.04
112 © Copyright Kofax, Inc. All information is subject to change without notice.
Unplug this product from the wall outlet and refer servicing to qualified service personnel
under the following conditions:
When the power supply cord or plug is damaged or frayed.
If liquid has been spilled into the product.
If the product has been exposed to rain or water.
If the product does not operate normally by following the operating instructions. Adjust only
those controls that are covered by the operating instructions because improper adjustment
of other controls may result in damage and will often require extensive work by a qualified
technician to restore the product to normal operation.
If the product has been dropped or the cabinet has been damaged.
If the product exhibits a distinct change in performance.
For complete removal of power from device disconnect both power supply cords!
The power supplies shall only be exchanged or serviced if the unit is switched off and both
power cords are removed.
The main socket outlet shall be installed near the equipment and shall be easily accessible!
For the power supply cord(s) use a flexible cord with a 1.5-4.5m (5-15 foot) length and
ground connection. Rating should be 230V/6A minimum.
An equipment grounding conductor that is not smaller in size than the ungrounded branch
circuit supply conductors is to be installed as part of the circuit that supplies the system.
Bare, covered, or insulated grounding conductors are acceptable. Individually covered or
insulated equipment grounding conductors shall have a continuous outer finish that is
either green, or green with one or more yellow stripes.
The attachment-plug receptacles in the vicinity of the system are all to be of a grounding
type.
This unit is intended to be installed in Restricted Access Locations only.
The provided CD-Drive (some models only) is classified as Laser Class I and complies with
21 CFR Subchapter J.
ATTENTION! Danger of explosion if internal Lithium Battery is replaced improperly. Replace
only with same type or with replacement type recommended by the manufacturer. Waste
disposal of used batteries according to manufacturer’s instructions.
10.2 Desktop Mounting
The KCS cabinet requires a place with easy access, power supply and enough space for ventilation.
At the rear must be enough room for cabling:
At the left and right must be enough space for ventilation: