FRITSCH ANALYSETTE 18 - Manual (Page 21)

5 Using the device
WARNING!
If the sieves and clamping devices used are not genuine
accessories, we assume no guarantee and exclude all lia-
bility for damage to the device or for personal injury.
WARNING!
Make sure before starting the machine that the sieves have
been clamped correctly and that there are no loose parts
on the device.
Failure to observe this will render void the guarantee, and
releases us from liability for any resulting damage to the
device as well as for any resulting personal injury.
NOTICE!
When using the 1000 mm guide rods, at least 4 test sieves
(50 mm in height) have to be used.
5.1 Clamping the sieve stack
5.1.1 TwinNut clamping system
1 TwinNut clamping nut
2 Guide rod
3 Sieve cover
Height adjustment:
n Pull apart the halves of the nut.
n Slide the nut down the guide rod to the sieve cover.
n Then close the nut again.
Clamping:
Tighten both TwinNut nuts at the same time.
Using the device
- 21 -