FRITSCH PULVERISETTE 2 - Manual (Page 19)

5 Initial start-up
Perform initial start-up only after all work as described in Ä Chapter 4
‘Installation’ on page 17 has been carried out.
5.1 Switching on
1. Connect the device to the mains.
2. Switch on the device using the mains switch (on the back of the
device).
3. The display of the digital timer lights up red.
5.2 Function check
1. Close the hood.
2. The laboratory mortar mill starts to work as soon as the START
button is pressed.
5.3 Switching off
1. Press the STOP button.
2. Disconnect the device from the mains at the mains switch (on the
back of the device).
Initial start-up
- 19 -