FRITSCH PULVERISETTE 6 classic line - Manual (Page 14)

2.6 Protective equipment
Protective equipment is to be used as intended and may not
be disabled or removed.
All protective equipment is to be regularly checked for
integrity and proper functioning.
For start-up, the hood (3) has to be closed.
The hood (3) is locked:
n without mains connection
n during operation
The hood (3) can only be opened, if the mill's drive is at
standstill.
2.6.1 Opening the hood without mains connection
CAUTION!
The emergency release must not be activated while the
machine is running! Disconnect the machine from the
mains before the emergency release. Failure to observe this
provision will void the guarantee, and releases us from lia-
bility for any resulting damage to the device or personal
injury.
1. Insert the included triangular key (A) into the bore hole on the
bottom side of the PULVERISETTE 6 classic line and turn it to the
right.
2. Unlock the latch (2) by pressing it.
3. Pull the hood (3) up to open it.
4. The mill can only be switched on again if the hood (3) is closed and
the safety lock (7) has been enabled again by turning the trian-
gular key to the right.
2.6.2 Imbalance switch
The device switches off if there is excessive imbalance. If this is the case,
then the counterweight has to be readjusted.
Safety information and use
- 14 -