Doepfer A-129-5 Vocoder Voiced/Unvoiced Detector - Manual (Page 3)

doepfer System A - 100
Voiced/Unvoiced Detector
A-129 /5
3
3. Controls
1 Gain
Use control 1 to set the level of input gain for the
speech signal at socket !.
2 Treble Boost
Control 2 is used to increase the level of the high
frequencies in the speech signal input. Often, using
this control makes speech more easily intelligible.
H To produce the best results, please also look
at the general instructions (chapter 5) in the
manual for the main vocoder modules, A-129
/1 and A-129 /2.
3 LED
This LED indicator 3 shows the status of the swit-
ching in the voiced / unvoiced detector:
• LED on : "Unvoiced"
• LED off : "Voiced"
4. In / Outputs
! Speech Input
The speech signal is patched into Speech-input !.
" Speech Output
Speech output " puts out the amplified and equalised
(treble-boosted) speech input signal. This output is
patched to the speech input socket on the A-129 /1
analysis module.
§ Gate Output
Gate output § puts out a gate signal, depending on
the status of the voiced/unvoiced detector:
• "Unvoiced" (LED 3 on) : "high"
• "Voiced" (LED 3 off) : "low"
You can use this gate signal for more elaborate sound
manipulation (see 5. User examples).