Doepfer A-100 - Manual (Page 6)

Even the A-100 DIY kits contain fuses. There is no difference between 115V and
230V for the fuse values as these fuses are used to protect the secondary circuits of
the supplies (i.e. the low voltages). The specified values are valid for the transformers
and wall outlet power supplies that are available from us for the DIY kits. If other
transformers or supplies are used the values have to be changed depending on the
specification of the transformer or supply. In this case the values specified in the table
are maximum values. If a transformer or supply with lower power is used the fuse
values should be changed according to the specification of the transformer or supply.
The
grey marked DIY kit is no longer available but has been added for the sake of
completeness.
Installation
• Do not expose the A-100 to rain or moisture.
• Operation is allowed only in a dry environment in a closed room but not in the open
country.
• The installation near a large amplifier or other equipment which uses powerful
mains transformers may cause hum.
• Do not install the A-100 in close proximity to equipment which produces an
electromagnetic field (monitors, computers, etc.), to avoid the possibility of mutual
interference.
• Do not connect the A-100 to a socket or outlet which is also being used by
equipment such as electric motors, lighting dimmers, etc, which can cause
interference. Use a separate outlet for the A-100.
• Use in a dusty environment should be avoided.
Care and maintenance
• Apart from cleaning the instrument, no other usermaintenance is recommended, of
the modules or system busses. Internal maintenance should be carried out only by
qualified technicians.
• For regular cleaning, use a soft, dry, or slightly damp cloth. To remove dirt, if
necessary, use a cloth slightly moistened with a very diluted mild detergent. This
should be more than sufficient to clean the instrument. Never use solvents like
petrol, alcohol, or thinners.
Type kit Fuse (5x20mm)
A-100 DIY #1 2500mA/2.5A träge / 2500mA/2.5A time lag (slow blow)
A-100 DIY #2 2 x 500mA/0.5A träge / 2 x 500mA/0.5A time lag (slow blow)