Cub Cadet 3000 Series User Manual

Page 57

Text mode
Original mode

8 - 3

Cub Cadet 3000

6. Line up the drive shaft with the new pump

adapter.

NOTE: If there is more than an 1/8” gap between
the drive shaft and pump adapter place the
spacer in between the the drive shaft and the
pump adapter. Do not force the spacer in if it
does not fit.

7. Install the new bolts through the drive shaft, pump

adapter, and the fan.

8. Finger tighten the shoulder nuts with the shoulder

facing the fan.

NOTE: The shoulder on the nuts fit into the fan
holes. See figure 9.

FIGURE 9.

Shoulder Nut

Shoulder Nuts

FIGURE 10.

7/16

Bolts

9. Tighten the hex bolts and shoulder nuts securing

the pump adapter assembly, using a 7/16 wrench
and a 7/16 socket. See figure 10.

REINSTALL THE FENDER ASSEMBLY.