Cub Cadet 3000 Series - Manual (Page 45)

6 - 11
Cub Cadet 3000
Lubricate and install both the gerotor star and outer
ring. Install by aligning the splines of the star with the
drive. After installation, rotate the gerotors outer ring
to align with the housing cap screw holes.
NOTE: The grooved side of both gerotor star and
outer ring must face upward.
Install the drive, making sure you fully engage the slot
on end of drive with the cross pin in the spool/sleeve
assembly.
Lubricate and install the o-ring seal into the groove
located in the wear plate.
Figure 43.
Figure 42.
Figure 41.
Install drive spacer in gerotor star.
Figure 44.