COP-USA DVRMPEG4-16LAN - Manual (Page 105)

③ : This button is for the IRIS adjustment. If the light situation of the area where camera is
located is too strong, press to decrease volume of light, and the light situation of the area where camera
is located is too weak, press to increase amount of light.
④ : Press this button to set the PTZF (Fig1.1.4 PTZF setting)
Internal: If the PC is connected to the DVR in the same local area network, you have to choose Internal
and do not need to reset the configuration.
External: If the PC is connected to the DVR through Internet, you have to choose External and setup the
PTZF Controller and Address of each channel.
Channel: Choose the channel which is connected with speed dome camera.
PTZ Controller: Choose the PTZF protocol, which is the same as the protocol set in Fast speed dome
and DVR. The protocol set in the PTZF PROTOCOL, which is the submenu of the LIVE menu in the DVR.
Address: Choose the PTZF address, which is the same as the address set in Fast speed dome and DVR.
The address set in the PTZF ID, which is the submenu of the LIVE menu in the DVR.
Take the channel 1 as example:
If the PTZF protocol set in the DVR is PELCO_D-2400, it means that the protocol is PELCO_D and the
baud rate is 2400kbps. If the PTZF ID set in the DVR is 01.Press the “Add” button to save the configuration,
the PTZF setting is as fig1.1.4 PTZF setting showing.
13