COP-USA ASH65NV - Manual (Page 7)

III Quick Guide of Installation
1. Modify the Protocol and the Address (jump over this section if no modification)
Take out the small metal cover on the bottom shown as dotted-lined part on Figure
3.1.1 to expose DIP switch of the address and the protocol shown as Figure 3.1.2. The
detailed drawing is shown as in Figure 3.1.1.
Figure 3.1.1 Figure 3.1.2 Figure 3.1.3
Shown as Figure 3.1.3, the 10-bit DIP stands for the addresses which can be from 0 to
1023. The 6-bit DIP stands for the protocols in which bits 1-4 mean the protocol
while bits 5-6 means the baud rate. Push the DIP downward means ON otherwise it
means OFF. For example the address in the figure means 1 while the protocol means
PELCO-D with the baud rate of 2400bps which can be found from the table.
Status of DIP Switch Address
of PT DIP-1 DIP-2 DIP-3 DIP-4 DIP-5 DIP-6 DIP-7 DIP-8 DIP-9 DIP-10
1 ON OFF OFF OFF OFF OFF OFF OFF OFF OFF
2 OFF ON OFF OFF OFF OFF OFF OFF OFF OFF
3 ON ON OFF OFF OFF OFF OFF OFF OFF OFF
4 OFF OFF ON OFF OFF OFF OFF OFF OFF OFF
5 ON OFF ON OFF OFF OFF OFF OFF OFF OFF
6 OFF ON ON OFF OFF OFF OFF OFF OFF OFF
7 ON ON ON OFF OFF OFF OFF OFF OFF OFF
8 OFF OFF OFF ON OFF OFF OFF OFF OFF OFF
9 ON OFF OFF ON OFF OFF OFF OFF OFF OFF
10 OFF ON OFF ON OFF OFF OFF OFF OFF OFF
11 ON ON OFF ON OFF OFF OFF OFF OFF OFF
12 OFF OFF ON ON OFF OFF OFF OFF OFF OFF
13 ON OFF ON ON OFF OFF OFF OFF OFF OFF
14 OFF ON ON ON OFF OFF OFF OFF OFF OFF
15 ON ON ON ON OFF OFF OFF OFF OFF OFF
３