Operating the speed dome, Call 9 5, Call 9 – COP-USA CD55-SDI User Manual

Page 7

6.OSD

FIRMWARE V1.0
Protocol: FACTORY
Dome Address: 001
Comm 9600,N,8,1

Initial Screen

After powering up, the camera will enter the
self-test mode and display the status screen(
as in the picture left).It contains information
about the model and current settings.

- V1.0:
- Protocol:
- Dome address:

- Comm 9600,N,8,1:

Current firmware version

control protocol which currently used

Address ID of speed dome. please refer to the section "Protocol

setup " for details.

current setting of the serial communication interface.

Baud rate. please refer to section "Baud-Rate setup" for details

No parity bit, 8 bit length, 1 stop bit. this setting can not be changed

9600:

N, 8, 1:

Operation Screen

The intial screen will stay remain on until any user action is being taken. If the power-
up action is set, the initial info wil vanish immediatly.

32.0

CAM TITLE

ZONE-1

285 78

18X

Pan degree

Zoom factor

Tilt degree

Zone description

Temperature

5.OPERATING THE SPEED DOME

PTZ operation

For the surveillance operation, the dome can be controlled from a keyboard device

, Multiplexer or DVR through RS-485 Interface. Make sure that the cable is connected
and the settings (baud rate, Address ID and protocol) of both keyboard and the dome
are configured correctly. For more description about the PTZ operation, please
refer to the user ’s manual of the keyboard.

Some products may not be available in your country, please contact our distributor for more details

ENGLISH

The operation screen can display additional
information.

Temperature: current temperature inside the
speed dome( °C)
Cam title: User definable camera title
Zone: Current zone name
Pan deg.: Pan angle, 0-359°
Tilt deg.:

Tilt angle, 0-90°

Zoom Factor: Zoom factor

Display of the information can be activate or
deactivate through the OSD menu. please refer to
the system setting for detais.

OSD Menu

How to start the OSD menu

The HSD Series are equipped with new OSD-Menu function. All operation functions and
camera related settings can be changed or modified here. In order to use the OSD function,
a telemetric controller device, such as Keyboard, DVR or other devices with similiar function
is necessarily required. please make sure that the device used is physically connected to the
dome properly, and all connection parameters are set correctly.

To start the OSD Menu, you need to press following key on the keyboard:

With or

In case a DVR is used for the OSD, select “goto preset 95” or 2 X “goto preset 9”. Please
refer to the DVR’s operation manual for more details.

Note that in some certain situations, it is not possible to enter the OSD menu:

1. the dome is running tour
2. performing PTZ operation
3. dome is receiving command other than OSD-request from the keyboard.

please stop the operation and try again.

2 X

Shot

Enter

Main menu and navigation

Main Menu

SYSTEM SETTING
CAMERA SETTING
FUNCTION SETTING
WINDOW BLANKING
ALARM
EXIT

After entering the OSD Menu, the screen will show menu
items . Use the controller’ joystick to navigate through
the menu’s main and sub items by moving in the
direction. The angle mark on the beginning of every
items indicates the selection.

UP, DOWN: - Moving between current menu items
- Changing the value in subitems
RIGHT: - Enter the selected menu item
- Confirm the value change and return to
item selection
LEFT: Exit from sub menu

For more inforamtion, please refer to the illustration on
the next page for the OSD menu structure.

Symbols and indicator

Cursor.

Sub item is selected. use up or down to change value

This item has subitem(s)

call

Enter

call

Enter

Shot

Enter