ChemoMetec SP-100 - Manual (Page 14)

1 Installation
4
Figure 5 The installation has been successful.
If the installation was successful the dialogue in figure 5 will appear. Click “Finish” to
complete the installation. Now the USB device driver for the NucleoCounter SP-100 is
successfully installed. It will not be necessary to redo the installation unless you wish to
use the NucleoCounter SP-100 on another computer or if you reinstall Windows 2000.
1.2 Installation of SemenView TM – Windows 2000 2
The NucleoCounter SP-100 CD-ROM contains the necessary software for the installation
of SemenView. SemenView allows viewing of images and results from the
NucleoCounter SP-100.
SemenView will be installed in a separate folder containing the necessary software (by
default C:\SemenView). Any data collected from the NucleoCounter SP-100 will also be
stored in separate data folders within that folder. It is necessary to place the
SemenView software in a folder in the root directory of the local hard disk named
"SemenView" as suggested by the installation software.
It is possible to choose a different location for the data but this will
disable the data collection capabilities of SemenView and is therefore
not recommended.
2 This description applies to Windows 2000 only. For Windows XP UK and Windows 98 2 nd
edition please refer to Appendix 2: Installation of the USB driver on other Windows
operating systems.