Checkline BP1 - Manual (Page 6)

 Electromatic Equipment Co., Inc.
-6-
4.0 MENU LEVEL OVERVIEW
Overview main menu
Edit Logs
Manual Logs
Clear Logs
Print Logs
Last Log
All Logs
Clear Logs
Send Logs
Manual Logs
Clear Logs
Options
Status
Options
Date / Time
Log Time
Language
Unlock
°C / °F
o Userlevel
BL On Time
Auto Off Time
o Online Send
o Online Print
Password
Reset
Materialcalib.
Next calibration curve
Previous calibration curve
Power off (3 sec.)
Watch the saved data (logs)
Save new value (log)
Power off (3 sec.)
Switch lower
Switch upper
Open this menu / Enter
Type selection menu
Store menu
Main menu
 Electromatic Equipment Co., Inc.
-11-
9.0 PRINT SAVED DATA
(Only possible with humimeter serial interface module in combination with
Schaller thermo printer)
To print your saved
logs, connect the
printer
to the
humimeter serial
interface using the
cable
that was
delivered with your
device.
To switch on the printer, press the ON/OFF button.
If the printer is correctly switched on, the green LED
blinks regularly. If it does not, replace the batteries and
try again.
Press the -key until you reach the menu (as in the
image on the right). Then choose „Print Logs“ from the
menu and confirm with
.
Now you can choose if you want to print only the last log
or all recorded logs. Confirm with
again. The selected
logs will be printed out.
Online Print
If your device supports online-printing, this can be
activated in the menu „Options“. If the option is active,
every newly recorded log will immediately be printed, if
the printer is connected and switched on.