Checkline TT-QC - Manual (Page 5)

AWS-QC Guide
OPERATION 5
N UMBER EDIT MODE
The current digit or decimal point flashes. Number edit mode never times out.
ENT
Save the current digit and go to the next digit. After editing the digits, the
decimal point can be moved. After the decimal point is saved, ENT exits
number edit mode and saves the number that was edited. During the decimal
point edit, the decimal point can be moved to a position where all of the digits
flash. If ENT is pressed at this point the number saved will be 0.000.
Up (ENG)
Increases the current digit or moves the decimal point to the right.
Down (MDE)
Decreases the current digit or moves the decimal point to the left.
CLR
Cancels number edit mode and restores the previous number.
V IEW M ODE :
Display toggles between the current location and the current reading at that
location. View mode never times out. When memory is off, the location
displayed is 000. The units are not displayed when viewing the saved
readings.
ENT
Exits view mode and sets the current memory location to the next empty
location if memory is on. If memory is off then it stays off.
Up (ENG)
Goes to the next memory location. If the maximum location used is passed
then pressing up wraps around to the first location.
Down (MDE)
Goes to the previous location. If the first location is passed then pressing down
wraps around to the maximum location used.
CLR
Exits view mode and sets the current location to the displayed location.
Readings will be saved from this location, overwriting saved readings at this
and higher locations.