Checkline ESM - Manual (Page 6)

Using the Control Unit
UP
Press and hold for tension, release button to stop motion. Located
on the face of the Control Unit.
DOWN
Press and hold for compression, release button to stop motion. Lo-
cated on the face of the Control Unit.
SPEED CONTROL DIAL
Adjust speed by turning the dial 0.5 – 13 in/min [13 – 330 mm/min].
Located on the face of the Control Unit.
POWER SWITCH
Use this switch, in the left rear of the Control Unit, to turn on and
turn off power to the test stand. Power is indicated by an amber light
on the face of the Control Unit
POWER PLUG RECEPTACLE
Located in the left rear of the Control Unit. Plug the power cord in
here.
CONTROL CABLE
Plug this cable into the lower male connector on the test stand, ad-
jacent to the motor.
Models ESM & ES30
5
ESM
SPECIFICATIONS
Load capacity 200 lbs [1000 N]
Speed range 0.5-13 in/min [13-330 mm/min]
Maximum travel 13.0 in [228.6 mm]
Maximum travel w/options 11.75 in [298.45 mm]
Speed variation with load ±0% (Stepper motor driven)
Speed accuracy ±5% of setting
Overload protection Max. 150% of full capacity
Power Universal input 80-240 VAC, 50/60 Hz
Fuse type 1.2 A, 250V, 3AG SLO BLO
Weight (test stand, only) 20 lbs [9.1 kg]
Control unit weight 2.7 lbs [1.2 kg]
User’s Guide
6
ESM
DIMENSIONS
in [mm]