Checkline HTM User Manual

Page 6

– 5 –

4.0 TAKING A MEASUREMENT

Range Switch

Pointer Button

1. Slide the Red Range Switch to select a multiplier for your application. If the

range is unknown, start at “x100” and adjust to lower range as needed. When

properly set, the needle will register a value between Min. and Max. on the dial.

2. Manually rotate the measuring shaft to engage the gear for the selected range.

3. Slide the measuring wheel contactadapter the over the shaft of the instrument.

Be sure to align the pin on the side of the shaft with the slot in the adapter.

Push on securely.

4. To begin measuring, bring the tip adapter into contact with the moving surface

of the material being measured. The gauge will take and display a reading,

either RPM, ft/min, min/min).

5. To lock in the reading, press and hold the Red Pointer Button to activate the

pointer. When the pointer button is released, the pointer will remain in the last

position.

6. To reset the pointer, press and release red button again.

Measuring Shaft

(Top View)

151 mm