Checkline CDT-1000HD - Manual (Page 3)

3
3.0 CONTENTS OF COMPLETE OUTFIT
1
3
2
The CDT-1000HD is supplied with the following accessories in a foam-fitted,
carrying case:
1. Meter with molded rubber shell
2. Reflective Tape (10 strips)
3. Two AA Batteries
4. NIST-traceable Calibrations Certificate (not shown)
5. Instruction Manual (not shown)
6
7.0 MEASURING RPM
1. Attach a piece of reflective tape to the rotating
element (shaft, pulley, etc.).
2. Aim the CDT-1000HD at the target
using the red visible light beam for
alignment assistance.
3. Press and hold the Measure key to begin taking
measurements. The “On-Target” indicator on the
LCD will flash on and off if the instrument is
properly aimed at the target (reflective tape).
4. Release the Measure key prior to removing the
instrument from the target. The last reading
will be retained on the LCD display.
Hints for Non-Contact Measurements
1. The non-reflective area should be larger than the reflective area.
2. If the rotating element is highly reflective, cover it with black
tape or paint to improve the contrast between the reflective tape
and the surface of the rotating element.
Reflective Tape