Cannon Instrument CT-1000HT (High Temperature Contant Temperature Bath) - Manual (Page 9)

7
CANNON ® CT-1000HT Constant Temperature Bath
Revision 1.1b—June, 2011; CANNON ® Instrument Company
2139 High Tech Road • State College, PA 16803 • USA
4. Remove the large piece of foam
packing from the inside of the
cabinet. Also remove the small
piece of foam from the float level,
located on the upper left-hand
corner of the inside of the cabinet.
5. Lower the glass jar into the cabinet
so it seats evenly on the rubber
support ring (see Figure 8).
6. Unwrap the two glass panels. Place
the thinner of the two piece of
glass in the slot closest to the jar
(see Figure 9).
7. Place the wider piece of glass in
the front slot furthest away from
the jar. The middle slot is left
empty for air circulation/cooling.
8. Replace the rear top cover. Align
the four holes, then insert and
tighten the screws.
9. Replace the front top cover.
Line up the four holes, then
insert and tighten the screws.
10. To ensure that the gasket forms
a tight seal with the top covers
of the bath, proceed as follows:
11. Pull out the drawer using the
handles provided, disconnect-
ing the two connection cables
as you do so.
CAUTION You will need to pull the AC line (power) cord through the rear panel
opening as you remove the drawer—you should not try to remove the
cord until you loosen the screw securing the power cord to its connection
on the back of the drawer).
12. Press down or pull up on the plastic release bars on either side of the
drawer track to release the drawer, then pull the drawer completely
free of the unit and set it aside.
13. When the drawer is removed, locate the four 1/4-20 set screws
visible at the top of the drawer opening underneath the bath.
14. Turn the set screws clockwise with the Allen wrench (included with
Figure 7: Placing gasket
Figure 8: Installing bath jar
Figure 9: Placing inner glass plate