Analogue Solutions Nyborg - Manual (Page 8)

Overview - contd
EXTERNAL CV CONTROL SOCKETS
Nyborg can be controlled via an external analogue sequencer, such as Oberkorn, using
the top panel CV sockets.
There are pitch CV sockets for each VCO PITCH1 and PITCH2, filter CUTOFF, GATE (to
trigger the EGs), EXT (to feed an external CV to various circuits).
Also, on the rear panel are two spare 6.35mm big jack sockets. Using these you can
route external audio through the filter. Set the VCA to BYPASS and use Nyborg as an
effects processor!
MOUNTING OPTIONS
Nyborg can be orientated and configured in several ways;
VERTICAL (TALL)
As standard, it comes as a vertical desktop unit just like it’s big brother Telemark.
HORIZONTAL (FLAT)
It is possible to reconfigure it so that it is a flat table top unit, like its cousin Leipzig-
S can be. This requires some minor screwdriver work.
WITH WOOD SIDES
In either of the above two configurations, optional wood side panels can be fitted.
These screw on from the inside of the unit, so no ugly screws will be visible on the
beautiful wood.
TWO (OR MORE!) SIDE BY SIDE
Two (or more!) units can be bolted side by side. And of course you can also fit the
optional wood sides to these, or, reconfigure them to be horizontal flat units. Two
units can be MIDI daisy chained for a duo-phone synth.
TWO UNITS RACKED
Two units can be bolted together (like above) and then you can also fit the optional rack
ear brackets, and rack mount the whole assembly.