Analogue Solutions Nyborg - Manual (Page 3)

Safety Instructions
PLEASE READ CAREFULLY BEFORE USING:
• Only use the correct power adaptor - 230V for UK/EU (110V for N.America).
• Never handle the adaptor with wet hands
• Never excessively bend the adaptor cable or get it trapped or place heavy
objects on it. If the adaptor cable becomes damaged, replace the adaptor.
• Ensure the unit is disconnected from the mains before moving or cleaning.
• Always disconnect the unit from the mains if there is lightning in your area.
• Ensure the unit is on a stable surface, and never place heavy objects on top of
it.
• Never allow young children or animals to operate the unit or adaptor.
• Do not use excessive force when using the controls or inserting cables to the
connectors.
• The unit should not be operated in the rain or near water and should not be exposed
to moisture.
• If the unit is brought from a cold environment to a warm one, the unit should be
left to reach the ambient temperature.
• Keep away from heat sources, such as radiators, ovens, heaters etc.
• Never allow it to get wet. Do not operate it near water, like pools, sinks,
bathrooms etc.
• Do not place beverages on or near it.
• Never open the case or attempt to make repairs. Refer any servicing to
qualified service personnel.
PREVENTING DAMAGE TO OTHER CONNECTED DEVICES
Nyborg has a very high dynamic range. It is capable of produce loud signals of very
high and sub-sonic frequencies that could blow inadequate speakers if played too
loud. It is recommended that input levels to external equipment (mixers, amp's etc.)
are kept low when first connected, and then slowly increased to a useable level.
MAINTENANCE INSTRUCTIONS
Any cleaning of the Nyborg case should be done with a clean lint-free cloth.
DO NOT USE SOLVENTS OR CLEANERS, as this will deteriorate the exterior
appearance of the equipment. Do not use a car wash or jet wash to clean this synth.
MOUNTING
Mounting does not mean 'place on the wall' or 'to make love to' in this instance.
PLACE
Nyborg soundly on any stable surface so it cannot fall off or over, causing it or yourself
injury.
POWER
The unit needs a 12 to 15V AC supply, minimum 500mA. DC Power supplies will not
work.