Panasonic SL-XP300 - Manual (Page 16)

Troubleshooting Guide
If the unit does not operate properly, check all of the following points, as well as connections
and the control positions of all components to this unit, before requesting professional servic­
ing. This table does not include checks for mistaken connections or incorrect settings of other
components. If the problem is not solved by this table or is not included in the problems listed
below, contact your Technics dealer for assistance.
Problem Causes Remedy
Disc holder cannot •The disc is not properly •Take it out and insert It
be closed. inserted. again.
Disc is inserted but •The Hold Switch is set to • Release the hold state.
number of tracks and “HOLD” position.
playing time are not • Disc is inserted upside • Insert disc again properly.
displayed. down.
•Disc is dirty.
•Wipe clean with soft cloth.
• Disc is scratched.
• Use a new disc.
• Disc is seriously warped.
•Use a new disc.
•A non-standard disc is
• Use only discs with the
inserted.
mark.
• Dew has formed inside
•Wait about 1 hour, then
the player.
turn on again.
About Compact Discs
Noise can result if the disc is dirty,
scratched, warped, etc. Please note the fol­
lowing points.
■ Compact disc identification...
n COMPACT
Mg®
DIGITAL AUDIO
Use only compact discs
bearing this mark.
fl Handling notes
• Be careful not to scratch the surface with
fingernails or other sharp objects.
• Do not bend the disc.
• Do not dry discs with a hair dryer.
• Do not write on the label side with a ball­
point pen, hard pencil or other hard writ­
ing utensil.
• Do not attach any type of paper, label,
etc. to the disc.
•If moisture forms on the disc, wipe it off
with a soft, dry, lint-free cloth before using
the disc.
■ Storage hints
Store the disc only In its own case.
Keep discs away from...
•Locations exposed to direct sunlight.
• Heating equipment and places where the
temperature is high.
• Places where there is high humidity or
excessive dust.
• In the glove compartment or rear ledge of
an automobile.
-16-