Panasonic CF-18 - Manual (Page 27)

Display (continued)
The cursor does not move in
scrolling area of the touch
pad
When the Microsoft® IntclIiMouse™ Wheel mode or the original mode is set for the touch
pad, only scroll operations are possible for the right part or bottom part of the touch pad. In
this case, cursor operations are possible by using the work surface excluding the right part or
bottom part. When no mode is set, the entire surface of the touch pad can be used for cursor
operations.
The e.\ternal display no
longer displays properly
When an external display is used that is incompatible with the power saving modes of the
computer, the display may not function correctly when the computer enters the power sav­
ing mode. In such cases, turn off the power to the external display.
During simultaneous dis­
play, the screen of the exter­
nal display becomes disor­
dered • Try changing the display by pressing
СЕЮ
+ C f D.
• If you continue to experience problems, try changing the display in the following menu.
4Winclo^2000)
[Start] - [Settings] - [Control Panel] - [Intel(R) Extreme Graphics],
[Start] - [Control Panel] - [Other Control Panel Options] - [Intel(R) Extreme Graphics]
Battery Indicator
The red indicator lights The battery level is very low (the charge is less than approx. 9% capacity).
Connect the AC adaptor. You can use the computer when the battery indicator light is or­
ange. If you do not have an AC adaptor, save your data and power off your computer. After
replacing the battery pack with a fully charged one, turn your computer on.
The red indicator blinks Quickly save your data and power ofT your computer. Remove the battery pack and discon­
nect the AC adaptor, then connect them again.
If the problem persists, contact Panasonic Technical Support. The battery pack or recharg­
ing function may be defective.
The orange indicator blinks Battery cannot be recharged temporarily because the internal temperature of the battery pack
is outside of the acceptable temperature range for recharging. Once the allowable range
requirement is satisfied, charging begins automatically. Your computer can be used nonnally
in this state.
The green indicator blinks In high temperature mode, the battery pack is discharging to a level of 80%* in normal
temperature mode. (Q= “Battery Power”)
Do not remove the battery pack while the battery indicator is blinking green.
* A
level of 80% in nonnal temperature mode is displayed as [ 100%] in high temperature mode.
The battery indicator blinks
green and orange alternately Warming up the system to prevent hard disk drive malfunctions at low temperature. Leave
your computer as is. Once the allowable temperature range requirement is satisfied, your
computer will start automatically.
Reference Manual
The Reference Manual is Is Acrobat Reader installed?
not displayed If Acrobat Reader is not installed, run [c:\util\rcader\acrorcader51 enu full.exe] in [Start] -
[Run] to reinstall the program. When installing the program, do not change the installation
destination folder. If the destination folder is changed, the Reference Manual cannot be
opened from the [Start] menu.
27