Installation (cont.), Antenna/cableconnections, Incoming cable from home antenna – Panasonic CT-31SF14 User Manual
Page 6: Incoming cable from cable company, Other video equipment, Care and cleaning, Picture tube (turn set off), Plastic cabinets, Wood cabinets, Remote control transmitter
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Installation
(cont.)
Antenna/CableConnections
Antenna Connection
- For proper reception of VHF/UHF channels, an external
antenna is required. For best reception an outdoor antenna is recomnnended.
Antenna Mode must be set to TV.
(Refer to Antenna Mode section.)
Incoming Cable from Home Antenna
Indoor
Typical VHF/UHF Antenna
75 Ohm
VHF/UHF
on Back of TV
300 Ohm
VHF/UHF
on Back of Set
or
_. _
75 ohm Matching
'
Transformer (Not Included)
Cable Connection
- For reception of cable channels, connect the cable supplied by your local cable company.
Antenna
Mode must be set to CABLE.
(Refer to Antenna Mode section.)
Incoming Cable from Cable Company
75 Ohm
VHF/UHF
on Back of TV
NOTE:
Certain cable systems offset some channels to reduce interference or have Premium (scrambled) channels. A
cable box is required for proper reception. Check with your local Cable company for compatibility requirements.
other Video Equipment
VCRs, Video Disc Players, Computers, TV games, and DSS equipment can also be connected to the antenna input
connection.
Care and Cleaning
Picture Tube (Turn set off)
Use a mild soap solution or window cleaner and a clean cloth. DO NOT USE ABRASIVE CLEANERS. Avoid excessive
moisture and wipe dry.
Plastic Cabinets
Wipe the cabinet with a soft cloth dampened with water or a mild detergent solution and wipe dry with a soft clean cloth.
Avoid excessive moisture. Do not use benzene, thinners or other petroleum based cleaners.
Wood Cabinets
When dusting or polishing the cabinet, use a clean soft cloth and stroke straight with the grain. An occasional coat of
furniture polish will help preserve the finish. Do not use benzene, thinners or other petroleum based cleaners. Do not
place objects made of plastic or rubber directly on top of the cabinet. A chemical reaction could result causing permanent
marring of the finish.
Remote Control Transmitter
To clean, wipe with a soft cloth slightly moistened with a mild detergent and then wipe dry with a soft clean cloth. Do not
use benzene, thinners or other petroleum based cleaners to clean the Remote Control Transmitter.
-
6
-