Panasonic PV-4664 - Manual (Page 26)

Timer Recording Using VCR Buttons
A tinner recording can be set up using the
buttons on the VCR. If necessary, the clock
can also be set.
POWER
^SELECTA PROGRAM SET
Important notes when using
a DSS receiver.
• When recording programs via a
DSS receiver the DSS receiver
must be left on.
• When recording programs via an
antenna or cable, the DSS receiver
must be turned off.
9
Hold down
REC/TIME.
and
Push FF to
enter the
program mode.
START STOP CH
SLP
ELECT START DATE
BY SELECT A / T KEY
NEXT. PUSH SET KEY OR
TO END PUSH PROG KEY
SET CLOCK -.............
/|N OST;ON
ELECT MONTH
BY SELECT A / T KEY
NEXT, PUSH SET KEY OR
TO END PUSH PHOG KEY
• If the clock is not set, pushing these
buttons will display the SET CLOCK
screen. In this case, proceed with
steps 2 and 3 to set the clock and then
steps 2-6 to set a timer recording.
• Once the VCR is in the Program mode, the PLAY, REC, FF,
and REW buttons on the VCR operate only as specified above
___ ; Push REW or PLAY to
^3 Qj.' I make your selection.
(for down) (for up)
Push FF to set
and move on to
the next item.
Push SET (FF) repeatedly to
move to a particular item for
setting or correction.
Items to be Set:
• recording DATE
• START time
• STOP time
• CH(annel), or LINE
•SPEED (SP, LP,SLP)
When the program is completed...
[77
and Q)
(at the same time)
Push REC/TIME
and FF to display
program contents.
To set the next program,
repeat steps 2, 3, and 4 before continuing with step 5.
§)
F7 and Q)
(at the same time)
Push REC/TIME and
FF to exit this mode.
■ Push POWER off
Oy a ..........to set the timer.
-¡EHia-
^ I ^
Multi Function Display
It is not possible to clear a timer program using the VCR
buttons. Please use the Remote Control.
When recording programs via a cable box, make sure the
cable box is left on. If the cable box cannot be controlled
with the VCR, you must manually select the desired
channel.
26