Warning, Ci&inlngiiie agnatori – Panasonic MC-V7347 User Manual

Page 17

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

iii

Wi^

;:;phiM|itei^<^glf-^ j^<:i|M|i

fax | >>|pH

WARNING

Personal Injury Hazard.

Be careful when removing agttatw. The belt tension is high. Failure to do so could result

in personal injury from agitator releasing quickly and snapping away.

Place the carpet/bare floor selector in the carpet position. Unplug and turn the unit over.
Remove the lower plate as described in the REMOVING/ INSTALLING THE LOWER PLATE

section.

Remove the agitator, carefuliy lift it out, and remove the

worn or broken belt from the brush pulley and motor shaft.

NOTE:

The two brush supports may come off along with

the two washers as you lift the agitator out.

DO NOT

lose

the two small washers.

Loop the new belt around the motor shaft and loop it

around the brush pulley. See illustration for correct belt

routing.

Use only a Panasonic Type UBS drive belt.

Before reinserting the agitator make sure the brush sup-
ports/washers are on correctly. See Illustration in

the REPLACING THE BRUSHES section.

After checking the brush supports, reinstall the agitator back into the housing grooves. After

installing the agitator, turn it by hand making sure that the belt is not twisted or pinched and all
rotating parts turn freely. Replace the lower plate as described in the REMOVING/IN STALLING

THE LOWER PLATE section.

Ci&INlNGiiiE AGnATORI

Switch oft the vacuum cleaner and unplug the power
cord before cleaning the agitator. In order to keep the
cleaning efficiency high, clean the agitator regularly.

Remove the lower plate if necessary. See the REMOV
ING/! N STALLING THE LOWER PLATE section

for the proper procedure.

Agitator - Cut off any carpet pile and lint
erjtangled around the agitator with a pair of
scissors as illustrated.