Panasonic SL-PD1348 - Manual (Page 10)

^ Ч ■ ■■■ ■■ '
. ..
........
■ ,'i'- V; I >
You can program up to 32 selections from the five discs in any order
as you desire.
1
PHooRWMOpe [In the stop mode]
Press PROGRAM MODE so
that the “PGM” indicator il­
luminates.
Each time the button is pressed, the dis­
play will change in the following order;
PGM-^DEL-»‘(off).
t_______________ 1
Illuminates
Press the desired disc button
(1-5).
disc : DCSC3 D1SC4 DISCS _ ,
n n n n
^ ^ KJ jq select disc 3, press DISC 3.
ъ
Specified disc number
The indication shows that all the
tracks on the disc are selected.
To program by means of disc numbers
only, repeat the above operation. (The
count will increase by one for each oper­
ation.)
SKIP
Press SKiP ^ to select
the track number.
For exanrtple:
To select track number 9, press
9 times.
V c у
П
Í
_„.!1WCK No.
Specified track number
Press PROGRAM MODE,
PROGRAM MOPe
( ) ОЙС _...’ t BAC< N o .
m
t
Program order
5 Repeat steps 2, 3 and 4 until
you have completed the de­
sired entry.
If you enter non-existing disc(s) or
track(s) soon after the loading drawer is
closed or when it is open, the corre­
sponding indicator illuminates and the
entry is included in the count. In the play
mode, the changer will cancel the non­
existing entry.
f ,
If you attempt a 33rd selection, the “-f ’
(futí) indication will be displayed.
6
To clear the entire programmed contents
[In the stop mode]
Press ■.
The display will indicate as below.
/1
To cancel program mode
PROGRAM MOPE [In the stop mode]
Press PROGRAM MODE twice.
The changer will return to sequential play
mode.
The programmed contents will remain stored in the memory until
they are cleared, even after the program mode is canceled.
Therefore, after using program play, it is possible to cancel the
program mode and use another play mode (except delete play) and
then still use the same program play again at a later time,
in addition, if the disc is replaced with another one, program play will
be carried out using the new disc. If non-existing entries occur at this
time, they will be canceled.
For your reference:
The program mode and the programmed contents will remain stored
in the memory even after the unit is switched off.
However, if the power cord is unplugged or the power supply is
otherwise interrupted for an extended length of time, the contents of
the memory will be erased.