Panasonic CF-VCW722 - Manual (Page 8)

Using the Drive
Using the Drive in the MS-DOS Mode
To use the drive in the MS-DOS mode*, configure the drive following the steps below after
performing the preparations page 6). If the steps listed below are performed with­
out completing the preparations Hrst, the drive will not operate properly.
* In the MS-DOS mode, discs can only be read.
“]
1
Select [Start], then select (Shut Down).
j
I
2
Select [Restart in MS-DOS mode], then select [OK],
3 3 Open the “CONFIG.SYS’' file for editing by issuing the following commands:
cd \t Enter )
I edit config.sys i Enter
)
I
J 4
Move the cursor to the line containing “OAKCDROM.SYS” and delete the characters
“rem” at the beginning of the line. (Deleting “rem” causes the item to become valid.)
DEVICEHIGH=C:\WINDOWS\COMMAND\OAKCDROM.SYS/D:MSCDOOO
(If this line is missing, add it.)
5 Press ŒiD+Œ) (File) .then ŒD (Save) to save the file. Then press CM) +CE).
then C X ) (Exit) to exit the Edit program.
6 Follow the same steps to edit the “AUTOEXEC.BAT’ file,
edit autoexec.bat ( Enter 1
7 Move the cursor to the line containing “MSCDEX.EXE” and delete the characters “rem”
at the beginning of the line. (Deleting “rem” causes the item to become valid.)
LOADHIGH C:\WINDOWS\COMMAND\MSCDEX.EXE /DiMSCDOOO /L:L
(If this line is missing, add it.)
S
Press
(
Alt
) +rp^
. then
(D
to save the file. Then press
caD+Œ)
, then
Œ)
to
exit the Edit program.
0 Restart the computer.