Panasonic KX-E2000 - Manual (Page 44)

DEFAULT SETTINGS
CODE
-f
D
0€F au LT
BACK
SPACE
J
You may change specific default settings of the typewriter. Default
simply means that certain settings are pre-programmed into the
typewriter and will remain that way until you change them.
The settings that can be changed are outlined under step #2
below. Changing the default settings:
1
Insert a sheet of paper
2
Press CODE + D
The numbers 60, 66, 6, P, N, D, 1 will print.
They represent:
60 - Page end - number of lines to print per page
(01 - 99 lines)
66 - Paper length - total number of lines on the paper
(01 - 99 lines)
6 - Lines per vertical inch
(5:5.25- legal, 6:6 -normal, 8:8 - 15 pitch)
P - Dec tab alignment character
(P:decimal point, C:comma)
N - Impact control
(N:normal impact, L:low impact)
D - Auto paper insertion point
(D:default - at seven lines, N:not default)
1 - Daisywheel
(1:100 series, 2:200 series)
3
BACKSPACE to the desired default setting
4
Press CORRECT and type the appropriate parameter
5
Press RETURN
The new default settings will print confirming your changes,
and communication parameters (N, N) are also printed. Com­
munication parameters are settings when you communicate
with interface option. These settings will remain the default
until changed again.
NOTE: • If you change the automatic paper insertion point, your default
prompt will automatically be changed. When CODE-i-D is pressed,
the Default setting will read:
60, 66, 6, P, N, N, 1
You can reset the auto paper insertion point back to the default
(seven lines from the top), by changing the second “N” to “D". •
• If the impact control parameter is set on L (low impact) and you
are not using this type of ribbon, Panasonic will not assume
responsibility for inconsistent print quality. If you experience
inconsistent print quality, change this setting to correspond with
the correct type of ribbon.