Panasonic KX-E2000 - Manual (Page 16)

USING THE TYPEWRITER
Automatic Paper Insertion
J
j
CODE
The Panasonic typewriter is pre-programmed to insert your paper
seven (7) lines from the top of the page. Place your paper in
the machine and pull the paper bail release lever toward you
until the paper begins to insert.
Changing the Paper Insertion Position
1
Place your paper against the paper support guide with the left
edge of the page aligned with 0 on the margin scale (located on
the top cover)
2
Pull the Paper Bail Release Lever towards you until the paper
begins to insert
3
Press RETURN. INDEX
(i)
or REVERSE INDEX
(T)
to position
the paper at the desired insertion point
4
Press CODE + A
The new position is now stored and will remain the point of
insertion until you change the setting again by following the
steps outlined above.
NOTE: You can reset the auto paper insertion point to the default setting
(7 lines) by changing the default parameter (refer to page 37).
Automatic Paper Eject
E
EJfCI
After typing a project, you can instruct your typewriter to au­
tomatically eject the paper.
Automatically Ejecting the Paper
• Press CODE + E
The KX-E2000 has been pre-programmed for standard
paper (66 lines), and will eject the paper based on that setting.
If you are using legal or ledger size paper (longer than 11"),
the paper will not eject fully from the typewriter unless you
change the paper length default setting (see page 37).