Panasonic RX-DS12 - Manual (Page 12)

Maintenance Technical Spécifications
■ Maintenance of external surfaces
Clean it with a cloth, dampened in a mild solution of soap
and water.
Do not clean the cabinet with benzine or thinner.
Avoid excessive moisture.
Avoid spray aerosol type cleaner. Some cleaners contain
corrosive chemicals that may cause interna! damage and
cabinet deformation.
■ Tape head care
To assure sound quality for recording and playback, be sure
to clean the tape heads after approximately every 10 hours
of use.
1. Open the cassette lid by pressing B/^ STOP/EJECT
((!))■
2. Press • ngg (CD), holding the tab Inside the deck
((D).
3. Clean the portions which contact the tape (the shaded
portions in the figure) with a cotton swab.
Do not use any solution other than alcohol for head
cleaning.
M Lens care
Open the disc holder and dean the lens with a blower (not
included). If the lens is extremely dirty, clean it with a cotton
swab.
Recommended product: Lens cleaner kit (SZZP1038C)
■ Radio
Frequency range
FM
AM
■ CD player
Sampling frequency
Decoding
Beam source
No. of channels
Wow and flutter
D/A converter
■ Tape recorder
Track system
Recording system
Erasing system
Monitor system
Frequency range (Normal)
■ General
Speakers
Output jack
Power requirement
AC
87.5-108 MHz
520-1610 kHz
44,1 kHz
16 bit linear
Semiconductor laser
(wavelength 780 nm)
2 channel, stereo
Below measurable limit
MASH (1 bit DAC)
4 track, 2 channel, stereo
AC bias
Multi pole magnet
Variable sound monitor
30-12,000 Hz
10 cm 4Qx2
Headphones; 4.2 mW, 32Q
230-240 V. 50 Hz,
Power consumption; 20 W
Battery 9 V [Six R20/LR20 (D, UM-1) batteries]
•Do not use rechargeable type batteries.
Dimensions (WxHxD) 470x158x254 mm
Weight 2.9 kg without batteries
Note:
Specifications are subject to change without notice.
Weight and dimensions are approximate.
MASH is a trademark of NTT.
Matsushita Electric Industrial Co., Ltd.
Central P.O. Box 288, Osaka 530-91, Japan
RQT4355-B
F1297K0 (D)