Panasonic PanaSync S70 - Manual (Page 22)

If trouble occurs in the display unit, perform the followina checks and take the
indicated action; if the troubie persists, please consult with your dealer.
Symptom Check Action
There is no display
power cord/plug
power switch
signal cable
The power management system
function might have acted (if so the
pilot LED will be yellow).
Plug the power cord into the outlet correctly.
Press the power switch.
Connect the signal cable correctly.
Release the power saving function by operating the mouse
or keyboard.
For additional details please read the Operation
Manual of the hardware you are using.
{Bn
The image is too large or
too smaii, or it is displaced
from the correct position.
The mode is not registered. Perform the desired settings and then save them by
waiting 20 seconds or pressing the Ш "Exit" key.
lO
The dispiay color is abnormal.
(Example) The color is
uneven or off-color.
The image distortion and or
tilt is large.
Is there something that produces a
magnetic field nearby?
(Examples) Television monitor,
another computer display unit,
speaker, etc.; was the orientation of
the monitor perhaps changed while
it was in use?
Remove the source of the magnetic field.
Perform degaussing.
Make sure your cable is correct.
Connect the signal connector correctly.
Try a different orientation.
Tl
inr
Tl
in
Tf
P£
Tl
ie background of the
tage is bright.
ie background of the
tage is colored.
ie character gets
irtially distorted.
ie image is dark.
The computer in use is Macintosh.
The signal output of the computer in
use is improper.
Press the operating keys Ш and Ш together at the same
time. You can then adjust this unit with the signal output of
the computer. One more pressing or execution of recall can
cancel this function.
* This function is effective for a specified computer. If there
is no problem in normal use, avoid the use of this
function.
[
h
J
Characters cannot bo
seen clearly; the image is
too dark.
Is the image signal level correctly
adjusted?
Is the brightness or contrast
adjustment turned all the way
down?
Check the video signal level from the computer and adjust
it in the correct direction.
Adjust the brightness and contrast.
The screen size and
position do not change.
Is the input synchronization signal
within the operating range?
Check the video output mode from the computer, and
select a mode within the display unit operating range.
For details, please read the Operation Manual of the
hardware you are using.
The front panel keys fail to
operate. Are 2 or more buttons being
operated at the same time?
Operate only one key at a time.
-17 -