Panasonic RX-DT670 - Manual (Page 15)

i:
RADIO
■ Manual tuning
Use tuning buttons to tune the radio to the desired broad*
cast frequency. The frequency changes up or down, each
time the or button is pressed, respectively. The
increment of each step is determined by the band selected.
1. Press the operation switch to turn on the unit.
2. Press “TUNER” button of the function select buttons.
3. Press the band button to select the desired radio band
(FM or AM).
The corresponding band indicator will appear.
F M P
■»£
o
: H u
4. Tune in the radio station using the tuning buttons.
Press the “+” or button for each step required until
the desired frequency appears on the display.
When tuning the station, the frequency display will
change as follows:
FM:
50 kHz step
AM: 9 kHz step
For FM reception, press the FM mode button to select
the “ST” (stereo). The stereo indicator will appear on the
display when the FM stereo broadcast is being received.
tf FM stereo reception is poor (excessive noise, the
stereo indicator flickers), press the FM mode button to
change to the monaural position (the stereo indicator
disappears). This will reduce the noise and provide clear
reception. However, the broadcast cannot be heard in
stereo.
Tuning indicator Stereo indicator
The stereo indicator disappears in monaural mode.
5. Adjust the volume and balance.
6. Adjust the graphic equalizer and S-XBS level controls to
the desired setting.
■ FM auto tuning
By pressing the tuning button (- or +) down for a few
seconds then releasing, the microprocessor automatically
tunes into the next station with a strong frequency.
1. Follow the same procedures as described in steps 1-3
of “Manual tuning".
2. Press the or tuning button for more then
1 second.
While tuning (the display is changing), the muting oper­
ates and the sounds cannot be heard.
If the correct reception cannot be done by the FM auto
tuning, the manual tuning is recommended.
3. Follow the same procedures as described in steps 5-6
of “Manual tuning".
15