Power source, Battery life, Ac power operation – Panasonic RQ-V200 User Manual
Page 7: Notes
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
PREPARATIONS
■ Power source (
Battery removal
Press battery “(g)” toward the 0 battery terminal
and remove it.
Battery life
When the batteries are weak, the OPR/BATT (op-
eration/battery check) indicator will become dim or
turn off during operation, and this unit will be
turned off to protect the memorized contents. If
the power turns off soon after increasing the
volume, pressing the operation buttons or turning
on the radio, replace the batteries. Replace within
30 seconds. (Failure to do so will result in the loss
of memorized settings.)
AC power operation
Connect the AC adaptor (Panasonic RP-AC33,
not included) as shown in the figure.
Notes:
•To operate on battery power, unplug the AC
adaptor unit from the household AC power outlet
and the DC input jack on the unit.
•If you leave the AC adaptor jack connected to
the DC input jack while disconnecting the AC
adaptor unit from the AC power outlet, the mem
orized contents will be cleared.
•When the battery indicator dims and you wish to
use the AC adaptor, be sure to connect the AC
adaptor before removing the spent batteries.
To prevent possible damage to this unit
•Load new battery with their polarities (0 and
0) aligned correctly.
•Do not apply heat to batteries, or internal
shortcircuit may occur.
•If this unit is not to be used for a tong period
of time, or used on AC mains supply, remove
the batteries and store them in a cool and dry
place.
•Remove spent batteries immediately.
•Do not use old and new batteries together.
Also never use an alkaline battery with a
manganese battery.