Panasonic CF-VDR721 - Manual (Page 8)

Using the Drive
Using the Drive in the MS-DOS Mode
4Win^Owi^98l
To use the drive in the MS-DOS mode, configure the drive following the steps below after
performing the preparations page 6). If the steps listed below are performed with­
out completing the preparations first, the drive will not operate properly.
1
Click the [Start] button then select (Shut Down],
2
Select [Restart in MS-DOS mode] and click [OK],
3
Open the ‘'CONFIG.SYS" file for editing by issuing the following commands:
cd\C Enter~^
edit config.sys i Enter)
4 Move the cursor to the line containing “OAKCDROM.SYS” and delete the characters
“rem” at the beginning of the line. (Deleting “rem” causes the item to become valid.)
DEVICEHIGH=C:\WINDOWS\COMMAND\OAKCDROM.SYS /DiMSCDOOO
(If this line is missing, add it.)
3
Press( Alt ) -t-[ F ) , then[ S ) to save the file. Then press ( Alt ] +C F ). then
( D
to
exit the Edit program.
6 Follow the same steps to edit the “AUTOEXEC.BAT” file,
edit autoexec.bat LEnterj
7 Move the cursor to the line containing “MSCDEX.EXE” and delete the characters “rem"
at the beginning of the line. (Deleting “rem” causes the item to become valid.)
LOADHIGH C:\WINDOWS\COMMAND\MSCDEX.EXE /D:MSCD000 /L:L
(If this line is missing, add it.)
5
Press C Alt ) -t-CED , then C S ) to save the file. Then press (M) +CE) , then to
exit the Edit program.
9
Restart the computer.