Yamaha PSR-400 - Manual (Page 35)

FEATURE REFERENCE
(MIDI)
MIDI
RECEIVE
ON/OFF MODE
□ □
A
CEiVE O
CLOCK
RECEIVE CHANNEL/CLOCK
The enable/disable status of all MIDI receive channels
is set via the MIDI section RECEIVE CH./CLOCK [A]
and [▼] buttons. The [A] button increments the receive
channel number shown on the display and the [T] button
decrements the receive channel number. The receive chan­
nel number is shown on the right two digits of the MULTI
DISPLAY while the status — “E” for enabled or “d” for
disabled — appears on the leftmost digit. The MIDI chan­
nel and status display appears while selection is in
progress and for approximately 2 seconds after both MIDI
CH. buttons are released. A *‘C” in place of the channel
number (1 through 16) stands for **CLC1CK/’ and allows
reception of the MIDI clock to turned on or off. If the
[RECEIVE ON/OFF] button is used while the MIDI re­
ceive channel or clock display is showing, the status of the
channel or clock can be switched between “E” and “d.”
RtCEIVE
ON/OFF □
A
CEIVE a
CLOCK
|STVL£/SP^ITVQ.CE _
E “
-V2£i______
1
1
1 f
style split voice
style ; SPLIT VOCE VOICE
P -
i p
c t o
style split voice ^ BEAT '
style ; SPLIT voice VOICE
P - r
p L
STVLE SPLIT VOtCe
Receive channel/clock settings apply to both the Remote Control
and Multi Voice receive modes.
Separate receive channel/clock settings are retained in each
PAGE MEMORY even when the power is turned off (see “PAGE
MEMORY" on page 14 for details).
MODE
The [MODE] button is used to select the MIDI receive
mode in which the PSR-400/PSR-500 is to operate —
Remote Control or Multi Voice.
Press the [MODE] button to call the mode display, then
use the same button to select “00” (Remote Control) or
“99” (Multi Voice).
□
The MIDI MODE is automatically reset to “00" whenever the
power is turned on, when a different PAGE MEMORY is se­
lected, or when the DEMO function is used.
■ The Remote Control Mode (Mode 00)
The Remote Control mode should be used when the
PSR-400/PSR-500 is to be connected to a second key­
board by which it is to be controlled. In this mode playing
the external keyboard has exactly the same effect as play­
ing the PSR-400/PSR-5(X)’s own keyboard. Further the
PSR-400/PSR-5(X) panel controls can be used as normal.
This mode is automatically selected whenever the PSR-
400/PSR-500 is turned on, when a different PAGE
MEMORY is selected, or when the DEMO function is
used.
Data Received In the Remote Control Mode
The PSR-400/PSR-500 receives and responds to the
following data received via the MIDI IN connector when
the Remote Control mode is selected:
• In addition to note and velocity data, the PSR-400/PSR-
500 responds to program change, sustain ON/OFF, vi­
brato, volume, pan, reverb (PSR-500 only), start, stop,
and MIDI clock messages.
• Program change messages 00 through 99 correspond to
voices 00 through 99.
33