Yamaha MC1203 - Manual (Page 7)

(6) Mix CUE switch
This switch routes the MiX signai to the CUE buss
(allowing you to monitor the MIX signal using head­
phones).
@ Mix BAL pot
This control adjusts the relative left/right balance of the
signals sent to the MIX outputs.
® AUX SEND (1,2 & 3) controls & CUE switches
These adjust the overall output level of the auxiliary
“mixes” set up using the AUX 1, AUX 2 and AUX 3 con­
trols on the input channels. The levels appearing at the
AUX outputs are controlled by the correspoinding AUX
SEND control. These controls should be used to make
an optimal match of the AUX SEND output level of the
mixing console with the input sensitivity of the effect
unit, signal processing device or amplifier used. The
CUE switches associated with each AUX SEND control
can be used to send the corresponding AUX SEND sig­
nal to the PHONES jack via the CUE/PHONES level
control. The AUX cue signal(s) will be added to any
other active cue signal. If you want to monitor only the
signal from a single AUX buss, make sure all other CUE
switches are turned OFF.
) Mix fader
This fader adjusts the level of the signal sent to the MIX
outputs.
MIX OUT
+ 4dB
OUT MIX
- 6 d B
AUX SEND
1, 2, 3
+ 4dB
)TB MIC (talkback microphone connector)
This female XLR-type connector accepts just about any
standard 50 to 6000 microphone for talkback pickup. A
gooseneck-type microphone that can be positioned for
the most comfortable operation is an excellent choice.
) TB SELECT (talkback assignment switches)
(AUX1/AUX 2/AUX 3/STEREO)
These switches allow the talkback signal to be fed to
the STEREO, AUX 1, AUX 2 or AUX 3 busses. Any
number of switches may be ON at the same time, so
you can route this talkback to a number of the console's
busses simultaneously.
)TB (talkback) level control
Adjusts the level of the talkback signal sent to the
selected buss(es).
) TB (talkback) ON switch
Pressing this switch activates the talkback microphone
plugged into the TB MIC connector allowing voice com­
munication from the console operator to the STEREO,
AUX, AUX 2 or AUX 3 busses according to the setting
of the talkback assignment switches.
) CUE/PHONES control and PHONES Jack
The CUE/PHONES control adjusts the level of the cue
signal sent to the PHONES jack so you can set the
most comfortable headphone monitoring ievei. The ste­
reo phone jack accepts any standard stereo headphone
set.
•The STEREO cue signal appears in stereo at the
phones jack, while the channel and AUX cue signals
are monaural.
f-' XXX LU ^ nZJIb =5
j a <<< O
TB MIC j] PHONES