Panasonic KX-T2386BA - Manual (Page 18)

Troubleshooting
Guide
Problem
r
The unit does not work when
I push any buttons.
The unit has been set to the
answer mode, but no incoming
message is recorded.
The unit does not function as
an answering machine.
However, a beep sounds
6 times and the call indicator
flashes on and off quickly.
r
While recording an outgoing
message, a beep sounds
6 times.
I push the button of a remote
controller, but the unit does
not respond.
The unit does not ring.
^ When the tape is played back,
the sound level is low, even if
the Volume Control is turned
up.
I have played back all the
recorded messages and I
want to record the next phone
call after the last recorded
message.
Cause & Remedy
• Plug in the AC adaptor again.
• Push the Answer System On/Off Switch
on.
•The cassette is broken (cut, worn out or
twisted) or not inserted. Replace the
cassette with a new one.
•The OGM is recorded improperly.
Record a new OGM.
The cassette might be broken. Replace it
with a new one.
Re-record your outgoing message.
Speak clearly, loudly and directly to the
microphone, and do not pause for over
2 seconds while recording.
Clean the heads. (See “Maintenance" on
page 18.)
• Save all the recorded messages by
using the “Save Messages” operation,
on page 11.
• In case of remote operation, just hang
up.
•Make sure that you are using your own
code number.
•Record the outgoing message in a quiet
place.
Ringer Volume Selector is set to “OFF”.
Set to “HIGH” or “LOW”.
1 7 -